As with June, the main tasks in July will revolve around presentation and the playing qualities of the course. In July, most clubs should be up to speed with their daily maintenance regimes; greens, tees, fairways and bunker hazards should be at their best, both in a visual and performance perspective.
As we move into the summer months and temperatures start to rise, we will need to be ensuring consistency across our putting surfaces. Reducing the cutting height and ensuring the cutting units are sharp should therefore be a priority.
Remember; do not bring the cutting heights down to more than a third of the total height of the plant at any one time. As the cutting units are to become used more regularly, the sharpness of the blade is of paramount importance to reduce the incidence of pressure from disease. If disease does occur, a judgement call will need to be made as to whether it will 'grow out' with good growing conditions, or the situation is not likely to improve.
The recent spell of dry / windy weather, particularly during the months of May and the latter part of June has increased evapotranspiration rates, resulting in many areas of the course drying out , It is important that both greens and tees and in some cases fairways are not left to dry out too much and become hydrophobic.
It is important to apply the correct amount of water and to ensure that the water is applied uniformly and to depth. In recent years Greenkeepers have resorted to applying wetting agents to help maximise the uptake of water into the soil profiles.
Presentation of the course will be at the forefront of the greenkeepers mind, ensuring the whole course is looking its best and everywhere is tidy and set for play.
Mowing frequencies should remain high, with mowers set at their summer heights. As levels of competitions and societies increase, there will be an emphasis on ensuring the quality of the playing surface remains high, with many trying to attain good green speeds and consistency of roll as a priority. Dropping the height to reach these speeds is an obvious temptation, but should not generally be used as a tool to achieve this. Instead, look at utilising rollers within your current maintenance programme to ensure good speeds without placing undue stress on your sward.
Mowing height should be maintained at around 3.5-6mm.
Tees - Mowing height should be maintained at around 10-15mm.
Fairways - Mowing height should be maintained at around 15-20mm.
Rough and Semi rough grass areas - Mow and tidy up these areas.
Horizontal growth should be controlled through the use of regular brushing and verti-cutting, with the latter occurring between every two to four weeks depending on your own situation. This should help keep on top of thatch accumulation as we move through the growing season. Grooming and brushing the greens to stand horizontal growth up before mowing will encourage a denser and more attractive sward.
Hole changing should be done once or twice a week depending on golf traffic, wear or competition requirements. The first and most important is good judgment in deciding what will give fair results. Study the design of the hole as the architect intended it to be played. Know the length of the shot to the green and how it may be affected by the probable conditions for the day - that is, wind and other weather elements, conditions of the turf from which the shot will be played, and holding quality of the green.
There must be enough putting green surface between the hole and the front and the sides of the green to accommodate the required shot. For example, if the hole requires a long iron or wood shot to the green, the hole should be located deeper in the green and further from its sides than should be the case if the hole requires a short pitch shot. In any case, it is recommended that generally the hole be located at least four paces from any edge of the green. If a bunker is close to the edge, or if the ground slopes away from the edge, the distance should be greater, especially if the shot is more than a pitch. Consideration should be given to fair opportunity for recovery after a reasonably good shot that just misses the green.
Fertiliser requirements will still be high, especially on USGA specification greens. As we move into a period of summer stress (drought), we should be thinking of utilising a better ratio of nitrogen to potassium. Potassium will play a major role in the plant in these periods, by affecting chemical and moisture transfer through the root system, as well as allowing better stomatal control by the individual plant. If potassium is inadequate, the level of metabolic activity will also reduce as enzyme structure can become markedly changed. This is an unwanted scenario during a period of stress. Look to a product with an NPK ratio of something akin to a 9-7-7 or a 12-0-8.
As we move deeper into the month, soil temperatures will reach very high levels in places, and the propensity for surfaces to dry out will increase under a warm sunny sky (doubly so if it is windy). Watering the greens will become a major consideration, but do not become reliant on this practice to reduce drought stress. Where possible, hand watering should be employed, especially on high spots, to help reduce the chance of dry spot.
Carry this out in a manner as close to nature as possible, soaking the surface at irregular intervals, rather than using a little and often approach as with topdressing etc. The use of modern wetting agent technology such as Qualibra, with a penetrant/polymer mix will allow soils to hold water at depth, thereby reducing irrigation costs and requirements whilst encouraging deeper rooting.
Water management will be key this month. Most courses will be looking to utilise wetting agents where possible, especially in well draining situations in the south, to save money and a valuable resource. Making the correct decision with regards to which product to purchase will be key. As with everything else, try not to rely solely on price, unless you are severely restricted in your budget.
Where possible, try to find one that suits your own situation, aims and application ability. Monitoring the effect they have on your own course's soil will provide you with a great idea of when the next application would be prudent, and how long the product lasts in your situation. This can be done with a moisture probe. There are a number of products to be browsed in the PItchcare shop at pitchcare.ie/shop. Upon application, remember to water the products in well to avoid scorch.
Growth regulators could also be a key tool this month. The advantages include a healthier root system and reduced top growth, with a view to reducing the drought stress the plant will be under. Reducing vegetative growth decreases the amount of energy required for growth, and the amount of moisture required to sustain high rates of photosynthesis. An application ofPrimo Maxx has been shown to increase density, colour and root mass even in hot and dry conditions, whilst also reducing mowing requirements and wear on machinery.
Top dressing & Aeration
Utilising the little and often approach with topdressing and aeration practices should help ensure a smooth putting surface, whilst increasing the general health of the root system. Try not to apply more than 0.5 tonnes per green of top dressing, and where possible try to use pencil tines or similar when aerating. Deep aeration should not be required during this month, due to the dry soil conditions, but regular spiking will allow more oxygen into the rootzone, aid root development and drainage potential during periods of heavy rainfall.
Products such as Oxy rush and Primo Maxx can help further enhance root zone and system health as well, respectively. In hot and dry situations such as we can expect, ensuring the plant uses the root system as the plant's 'fridge' will be very important. A monthly application of these products can help provide aerobic conditions beneficial for soil micro-organisms and divert the supply of nutrients from vegetative to root growth, thus ensuring that the basis for a healthy sward is maintained
Monitoring the performance of your playing surfaces is a key skill that should be adopted by all Groundsmen and Greenkeepers. With the aid of modern technologies, tools and a camera, you can now monitor the performance and the condition of your sward in many ways.
For many years, the turf industry has promoted the use of Performance Quality Standards PQS to ascertain the standard of sport pitch maintenance.
It is important to survey and measure the performance of your facilities; with modern technologies we can now measure all manner of aspects of the pitch/golf green or artificial pitch to ensure it meets any stated guidelines by the sports governing bodies.
These can include measuring sward height, composition of grass species, soil temperature, weed content, levels over a 3m level, hardness and infiltration rates (porosity) of the soil rootzone.
In recent years, we have seen the development of GPS mapping devices that can measure, chlorophyll , moisture content and deviation in levels. Soil tests will also help determine soil type, nutrient status of the soil, organic matter content, CEC capacity and soil pH.
Keeping a record of these parameters will help you have a better understanding of what is going on within your playing surface and enable you to make better decisions on what maintenance inputs you will need to undertake to maintain surface playability.
Weed growth is very active during July, requiring the use of selective herbicides. These are more effective when the plant is actively promoting growth. Always follow manufacturers' guidelines.
Moles and rabbit damage repairs can be undertaken as and when required.
Keep an eye on fungal disease attack, and use approved fungicides to treat infected areas. Scarring of the playing surface is normally reduced as grass growth is usually dominant and vigorous in May, reducing the need to use fungicide treatments. However, there may be a need to apply a preventative fungicide treatment in the lead up to important competitions or matches.
Golf clubs invest a lot of money in buying equipment, they genarally have large fleets of mowers and other course machinery such as sprayers, top dressers, aerators and many other small mechanised hand tools, all of which require regular servicing and maintenance.
Having a good wash down facility is an essential tool for keeping equipment clean, there are a number of companies who spcialise in the installtion of these facilites.
In recent years, we have also seen clubs investing in their own grinding machines for keeping the mowers sharp; running mowers with sharp blades improves the quality of cut and ensures the plant is kept stress free.
Pitchcare provide a range of courses suitable for golf courses. In most cases, the courses can be held on site using the club's own equipment and machinery.
Some of the courses available are:
Chainsaws - CS30 and CS31
H&S Refresher Training on Combined Turf Care Equipment; Tractors and Trailers; All Mowers (Ride-on and Pedestrian)
Machinery Courses on ATVs; Tractors: Brushcutters/Strimmers; Mowers (ride-on and Pedestrian)
Pesticide Application (PA courses)
Stem Injection of Invasive Species (Japanese Knotweed etc.)
Basic Trees Survey and Inspection
More details about all the courses can be found here, or you can email Chris Johnson for information.
Bunkers / Daily:- Inspect, weed and rake bunkers.
Course Inspection / Daily:- Inspect greens, tees, flags and hole positions for damage or vandalism.
Ponds, lakes and streams /Weekly:- Inspect all water features on course, cleaning out any unwanted debris and litter.
Seed bare and worn areas / When conditions allow:- Greens, Tees and Fairways. Over seeding of sparse or bare areas can be continued, the rise in temperature will help germination. Use germination sheets to aid this process but remove the sheets regularly to check for diseases. Remember that without good seed to soil contact the operation is useless. Ensure you use new seed as old material may not give you the required germination rates. Remember, bents and fescue grasses require higher soil temperatures for successful germination.
Tee boxes, pegs / As required:- All tee boxes, tee pegs and competition markers should be inspected daily, cleaned and moved to new positions as required.
Top dressing / As required:- Greens and Tees. Ensure you have enough top dressing material for any renovation works that may still be carried out in May.
Wetting agents / As required:- If wetting agents are being used, they are generally applied monthly throughout the season.
Woodland and conservation areas / As required:- High and strong winds can damage trees on golf courses. Inspect and repair or remove damaged trees. It is important to inspect trees regularly (heath & safety) to reduce the likelihood of a golfer being struck by tree debris.
Machinery (Repairs & Maintenance)/ Daily:- Inspect and clean machinery after use, service and repair damaged machinery.
Marking out / Weekly:- Mark out trolley areas, out of bound site areas and range markings.
Materials/ Monthly:- Estimate and order seed, loams and fertilisers, fuels and other consumables.